Guided Setup

Protocol Builder

Select a peptide and instantly get a complete reconstitution protocol with pre-filled dosing, vial strength, and syringe calculations. One click from peptide to protocol.

29Peptides Supported
6-StepReconstitution Guide
100%Free to Use

Educational Tool Only

This protocol builder is for educational purposes only. All dosages are sourced from published clinical trials, peer-reviewed journals, and official FDA prescribing information where available. This does not constitute medical advice. Always consult a qualified healthcare professional before using any peptide.

Step 1: Select Your Peptide

Choose a peptide to auto-populate the reconstitution calculator with typical dosing parameters.

Reconstitution Tool

Peptide Dosage Calculator

Easily calculate accurate dosages by selecting your parameters below. Choose your dose, vial strength, and water volume to get precise syringe measurements.

Educational Tool Only

This calculator is provided strictly for educational and informational purposes. It does not constitute medical advice, diagnosis, or treatment recommendations. Always consult a licensed healthcare professional before using any peptide products.

Dose of Peptide

Strength of Peptide

Water Volume

Results

Peptide Dose: Select dose

Draw Syringe To: Select values

0102030405060708090100

Your Vial Contains

Select values

Concentration

Select values

How to Calculate Peptide Dosage

Our peptide calculator simplifies the process of determining the correct peptide dosage. Follow these steps for accurate results.

1

Set Your Dose

Choose the desired dose in milligrams (mg). This is the amount of peptide you plan to inject each time.

2

Peptide Amount

Enter the total amount of peptide in your vial. Common amounts include 5mg, 10mg, or 15mg.

3

Add Water Volume

Enter the volume of bacteriostatic water (mL) used for reconstitution. This affects the concentration.

4

Read Results

The calculator shows the exact syringe units to draw, concentration, and number of doses per vial.

Step-by-Step Guide

How to Reconstitute Peptides

Follow these steps to properly reconstitute your lyophilized peptide powder with bacteriostatic water. This guide is for educational purposes only.

1

Prepare Your Workspace

Wash your hands thoroughly. Work on a clean, flat surface. Gather all supplies: peptide vial, BAC water, alcohol swabs, and insulin syringe.

2

Clean the Vial Tops

Use an alcohol swab to wipe the rubber stopper on both the peptide vial and the bacteriostatic water vial. Allow them to air dry for a few seconds.

3

Draw Up BAC Water

Using a clean syringe, draw up the desired amount of bacteriostatic water. Common amounts are 1mL or 2mL. Use our calculator above to determine the right amount.

4

Add Water to Peptide Vial

Insert the needle into the peptide vial. Slowly inject the water along the inside wall of the vial. Do NOT spray directly onto the powder, as this can damage the peptide.

5

Gently Swirl (Never Shake)

Gently swirl the vial in a circular motion until the powder is fully dissolved. The solution should become clear. Never shake vigorously; this can break down the peptide molecules.

6

Store & Calculate Dose

Store the reconstituted vial in the refrigerator (2-8°C). Most peptides remain stable for 3-4 weeks. Use our calculator to determine the exact syringe units for your dose.

Important: This reconstitution guide is for educational purposes only. Always follow the specific instructions provided by your healthcare professional and peptide supplier. Never self-administer any substance without proper medical guidance.